installing phantom 2 standard camera guard

If this feature has been disabled and your battery runs out during flight, it is going to crash. Phantom Battery If the Phantom battery runs low, this will trigger Failsafe mode automatically if this has been enabled in the Vision App. This next video gives you some great tips on how and where to get the best return to home point. Getting the Home Point set correctly is extremely important. It is recommended to lift off only after Ready to Fly status is confirmed for the safety of being able to fly back to home point successfully in case the Failsafe mode is initiated. Home Point: When the aircraft is initializing the “Ready to Fly” status, the aircraft will record the current GPS coordinates as the home point. This video is packed with great information and tips regarding the Phantom 2 failsafe mode. Note: The Phantom cannot avoid obstacles during failsafe so it is important when flying that your Phantom is above buildings and trees etc. Ready to Fly – Automatic go home and land: The flight control system will automatically control the aircraft to fly back to the home point and land. Note that the aircraft may be drifting during the descent and landing process. Ready to Fly (non-GPS) – Automatic landing: The flight control system will try to keep the aircraft level during descent and landing. When Failsafe mode is initiated whether it is in the Ready to Fly or Ready to Fly (non-GPS) mode.

There is EMI or EMF interference causing a signal problem with the remote controller.įailsafe works differently depending on the mode the Phantom is in.There is an obstacle obstructing the signal between the remote controller and the quadcopter, reducing the distance the signal can travel.The aircraft has flown out of the effective communication range of the remote controller.The remote controller is powered on but the S1 is toggled in the position triggering the Failsafe (this may have been configured in the Phantom 2 Assistant software).The following situations will make the Phantom enter Failsafe mode The flight control system will automatically control the Phantom to return to the home point and land to reduce damage. Your Phantom quadcopter will enter Failsafe mode when the connection from the remote controller is lost. Prevent Phantom GPS Signal Loss On Your Phantom GPS Signal Loss And Failsafe Function If you are finding that you are constantly losing the FPV signal or are flying close to the maximum FPV range on your Phantom, then it is a good idea to extend the Phantom 2 FPV range. Remember, if your Phantom is still under warranty and you’re having a lot of GPS signal problems, then the best solution would be to contact the place of purchase and have the Phantom returned for a new one or have the GPS issue fixed under warranty. I hope these videos and the knowledge within will be of great assistance to you. A lot of the tips here are very practical and you can use this information to guide you in troubleshooting any drone not just a Phantom.įixing the Phantom GPS problem may take one solution or you may have to tackle the problem with different preventative action. This article with videos will give you some tips, checks and pointers to prevent GPS signal loss on your Phantom. If your Phantom is losing the GPS signal regularly, you lose the enjoyment of flying and with each GPS signal loss, there is always a chance of your Phantom crashing. If the Phantom is out of sight, the anxiety is even greater until you see your Phantom coming back to you.

When your Phantom loses GPS signal and enters failsafe mode, their are always some anxious moments as you are unsure whether your quadcopter will return to its home point.

Installing phantom 2 standard camera guard